Installation Instructions
Required Items
-
Clean microfiber cloth
-
Mild soap & water or alcohol wipes
-
Heat gun or hair dryer (optional, for cold weather)
-Step 1: Prepare the Surface
Thoroughly clean the roofline and upper edge of the rear window. Ensure the surface is completely dry and free of dust, wax, and oils for maximum adhesion.
-Step 2: Test Fit the Spoiler
Hold the visor spoiler against the roofline to check alignment. Use masking tape as reference markers if needed.
-Step 3: Apply the Spoiler
-
Partially peel back the adhesive tape liners at both ends of the spoiler.
-
Carefully position the spoiler using your reference points.
-
Secure the ends first, then slowly remove the remaining tape liner while applying firm, even pressure along the length of the spoiler.
-Step 4: Secure & Finalize
-
Press firmly along all edges to ensure proper bonding.
-
If installing in colder temperatures, gently warm the tape area with a heat gun or hair dryer.
-
Allow 48 hours before washing the vehicle or exposing it to heavy rain.
